Why is the outdoor unit iced over or buried in snow?
In heating mode the outdoor coil runs colder than the air around it, so frost forms on it. A working unit clears that frost with a defrost cycle. The fan stops for a few minutes and the unit may give off steam. That is normal.
A coil that stays a solid block of ice is not normal, and neither is a unit sitting under a drift. The Thornbury climate station on this shore averages 266.6 cm of snow a year, including 79.1 cm in January and 70.8 cm in December. That is enough to bury an outdoor unit on a low pad. Once snow blocks the coil, the unit cannot draw air and the defrost cannot clear it. The house then falls back on backup heat or goes cold.
Before calling, clear the snow off the top of the unit and away from all sides by hand or with a broom. Do not chip ice off the fins with a shovel or any tool, because the fins bend and the coil can puncture. If the coil ices solid again once the unit has run for a while, the likely cause is the defrost control, a sensor or a low refrigerant charge. Those need a technician.
Why is the house cool, or the backup heat running all the time?
A heat pump delivers warm air, not hot air. Air from a register or a wall head can feel lukewarm to the hand and still be normal. A house that will not hold the thermostat setting is not normal.
Common causes are a thermostat left on emergency or auxiliary heat, a clogged filter or dirty indoor head, low refrigerant from a leak, an outdoor fan that has stopped, or a reversing valve stuck in cooling mode. Thornbury's normals give an average January daily minimum of -9.9 °C, and many nights go colder, so a heat pump leans on its backup more in deep winter. But if the electric strips, or the furnace in a hybrid system, run far more than they used to, part of the heat pump has usually stopped working.
Check the thermostat mode, the filter and the breaker for the outdoor unit. If the breaker has tripped, reset it once. If it trips again, leave it off and call. If the furnace half of a hybrid system will not light, that is a furnace repair call.
What should be done before the house sits empty for the winter?
In the 2021 census, usual residents occupied 10,811 of the town's 13,768 private dwellings. Many of the others sit empty through the winter, with the heat left on and nobody to clear the snow. That is when a heat pump is most at risk: a drift builds over the outdoor unit, the system loses capacity, and either the backup heat carries the house or nothing does.
Before you close up, have the outdoor unit raised on a stand or wall bracket above the usual drift line. Check that the condensate line from each indoor head drains freely and cannot freeze where it leaves the wall. Fit a clean filter, and set the thermostat to a holding temperature rather than off. Ask a neighbour or property watcher to clear the unit after heavy snow. A pre-winter visit under furnace and AC maintenance covers the controls, drains and defrost.
If the house also has a gas furnace or fireplace, the side-wall vents need clearing too. The Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area in a home with a fuel-burning appliance. Test those alarms before you leave.
Can a house with baseboard heaters and no ducts have a heat pump?
Yes, and this is where a ductless heat pump fits best. Springhurst Beach, New Wasaga Beach and Brock's Beach were annexed in 1974 and Bower's Beach in 1994. Year-round houses from that period were often built with electric baseboards and no ductwork. The early cottages between Mosley Street and the bay, and in Oakview Beach, were summer buildings. Heat came later as baseboards, space heaters or a furnace in the crawlspace.
A ductless system has one outdoor unit and one or more wall heads inside, joined by refrigerant lines run through small holes in the wall. No ducts are cut into the house. The baseboards can stay as backup for the coldest nights and for rooms the heads do not reach. In cottages with thin insulation, the heads are sized to the actual heat loss, and the technician will say where insulation would do more than extra equipment.
The same system cools in summer, but heating is what pays for it here. The area averages 4187.5 heating degree-days against 207.8 cooling degree-days a year. For the cooling side, see the guide to air conditioning for a house with no ductwork.
When does a hybrid system make sense?
A hybrid system puts a heat pump and a gas furnace on the same ductwork. The heat pump handles mild weather and the furnace takes over in deep cold. It suits houses that already have ducts and gas, such as the newer homes around Sunnidale Trails, and older ducted houses where the furnace is due for replacement anyway.
Not every street has a gas main. The gas utility's new-customer page checks by postal code whether a property is in its service area, and it has a separate route for homes with no gas on the street. Without gas, the choice is a heat pump with electric backup or another fuel. That comparison is in the guide to the cheapest way to heat a Wasaga Beach home.
Many houses built between the 1960s and 1990s have a furnace vented through the chimney. Replacing it as part of a hybrid often means lining the chimney or venting the new furnace through the side wall. That work is covered under furnace installation and replacement.
How is a heat pump installation done?
The technician measures the house: room sizes, windows, insulation, crawlspace and any existing ducts. The system is sized to that heat loss, not to the wattage of the old baseboards or the label on the old furnace. The equipment is a cold-climate model suited to winters on this shore.
The outdoor unit goes on a stand or bracket above the drift line, away from the roof drip edge and from where snow is piled off the driveway. Snow sliding off a roof can flatten a unit or bury it overnight. The refrigerant lines and condensate drain are routed so they cannot freeze or be crushed.
Rebate programmes change. We check which ones are open when you are deciding and what they require, such as an energy assessment before and after the installation. You approve a written price before any equipment is ordered. Work is performed by 313A refrigeration and air conditioning mechanics. On hybrid systems, work is performed by TSSA-certified gas technicians, and the gas side is installed to the CSA B149.1 Natural Gas and Propane Installation Code. To start, request a quote.
