Did the furnace stop after a snowfall?
Check outside before you check the basement. Newer houses, such as those in Sunnidale Trails, have condensing furnaces that draw in air and exhaust through two plastic pipes in the side wall. When snow drifts over those pipes or the exhaust ices up, a pressure switch shuts the furnace off. The furnace is not broken; it has stopped itself for safety.
Snow here is heavy. Environment Canada's 1981-2010 normals for Thornbury Slama, the climate station on the shore west of town, show 266.6 cm a year, with 79.1 cm in January and 70.8 cm in December. That is enough to bury a vent set low on the wall, and the gas meter next to it.
Clear the pipes and the meter by hand, because a shovel blade can crack the plastic. Turn the furnace switch off, wait a minute, then turn it back on. If it lights and stays lit, keep an eye on the pipes through the next storm. If it will not light, or the exhaust keeps freezing, call. The cause may be a blocked condensate trap, or the vent ends may need to be raised above the usual drift line.
What if the CO alarm sounds or you smell gas?
Get everyone outside first. Do not try to reset the furnace while the alarm is sounding. If you smell gas, do not use light switches or the thermostat. Leave the house and call the gas utility's emergency line from outside, then call us for the furnace.
The Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area in a home with a fuel-burning appliance, a fireplace or an attached garage. If your alarm is missing or past its date, replace it before the cold weather sets in.
On a furnace, carbon monoxide usually points to a blocked side-wall vent, a chimney that no longer drafts, or a cracked heat exchanger. A cracked heat exchanger can let combustion gases into the air the blower moves through the house, so it is not patched and left running.
Why is it blowing cold air, short cycling or making noise?
Cold air from the registers means the burners are not lit while the blower runs. Common causes are a failed igniter, a flame sensor coated with residue, or, on a condensing furnace, a blocked condensate line that trips the pressure switch. Sometimes the thermostat fan is just set to on instead of auto.
Short cycling means the furnace lights, runs briefly and shuts off. A clogged filter makes the heat exchanger overheat and trip the limit switch. A dirty flame sensor drops the flame after a few seconds. A furnace that is too big for the house heats it fast, shuts off and starts again, which wears out parts.
Each noise has its own short list of causes. A bang at start-up is usually delayed ignition from dirty burners. A squeal or grind points to the blower or inducer motor bearings. A rattle can be a loose panel or a failing inducer.
Before you call, check the filter, check the thermostat is set to heat and has fresh batteries, and check the furnace switch and the breaker. If all of that is fine, the fault is inside the cabinet.
What is different about an old cottage or a 1970s beach house?
The first cottages went up in the early 1900s, mostly closely spaced on side streets between Mosley Street and the bay, with Oakview Beach joining the village in 1966. They were summer buildings with no central heat. A furnace was added later, often in the crawlspace. Expect improvised ductwork, thin insulation and tight access. Damp crawlspaces corrode controls, mice chew wiring, and ducts come apart so rooms stay cold while the furnace runs. When you call, say the furnace is in a crawlspace and how big the hatch is.
Springhurst Beach, New Wasaga Beach, Brock's Beach and Bower's Beach were mostly built from the 1960s to the 1990s. Many of these houses have a mid-efficiency gas or oil furnace that vents into a chimney. Faults here often come from the chimney: a blockage, a deteriorated flue, or poor draft that trips the spill switch. If replacing the furnace makes more sense than repairing it, the chimney will likely need a liner. See furnace installation and replacement.
What about a furnace in a house that sits empty all winter?
In the 2021 census, 10,811 of Wasaga Beach's 13,768 private dwellings were lived in by usual residents. A good share of the rest sit empty through the winter with the heat on and nobody home. If the furnace stops in January, nobody finds out until the pipes have frozen, and a vent drifted over in a storm stays buried because nobody is there to clear it.
Have someone check the house after each big snowfall, including the vent pipes and the gas meter. A thermostat that alerts you when the temperature drops can warn you early. A service visit before you leave in the fall catches the condensate line and venting problems that cause most mid-winter shutdowns. See furnace and AC maintenance.
If you are calling about an empty property, tell us how the technician gets in and where the water and gas shut-offs are.
How does a repair visit go?
The technician goes over what you saw and heard, tests the furnace and shows you the fault. You get a written price and approve it before any part goes in. If the furnace is old and the repair is poor value, the technician will say so and give you the replacement option to compare.
Work is performed by TSSA-certified gas technicians, and repairs to gas and propane furnaces follow the CSA B149.1 Natural Gas and Propane Installation Code, adopted under Ontario Regulation 212/01.
To book, use the contact page and tell us what the furnace is doing, roughly how old it is and what kind of house it is in. For other work, see all services.
