Skip to content
Wasaga Beach Furnace

Furnace installation in Wasaga Beach

Furnace installation and replacement in Wasaga Beach

A new furnace has to suit the house it goes into: a crawlspace in an old cottage, a chimney in a 1970s beach house, or side-wall vents facing a snowy winter. We size high-efficiency furnaces to the house, check the venting and the gas supply, and write the price down first. Not sure it needs replacing? Start with furnace repair.

High-efficiency furnaces sized to the house, with a written price first.

Which faults mean the furnace should be replaced?

A cracked heat exchanger is the main one. It can let combustion gases, carbon monoxide included, into the air the blower pushes through the house. A furnace with a cracked heat exchanger should not be left running. Other signs build up more slowly: the same part failing every winter, parts no longer made for the model, rooms that never warm up, and a burner that runs and runs on cold nights without catching up.

If the furnace has simply stopped, start with furnace repair. Many no-heat calls come down to an igniter, a flame sensor or a blocked vent, and a repair is the right answer. Replacement comes up when the fault, or the age of the unit, makes a repair poor value. In that case you can have the repair price and the replacement price in writing and compare them.

While you are thinking about the furnace, test your carbon monoxide alarms. Work is performed by TSSA-certified gas technicians, and the Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area of a home with a fuel-burning appliance, a fireplace or an attached garage.

Does a 1960s to 1990s house need a chimney liner?

Often, yes. Springhurst Beach, New Wasaga Beach and Brock's Beach joined the town in 1974, and Bower's Beach followed in 1994. Year-round houses from that period were commonly built with a chimney-vented mid-efficiency gas or oil furnace, or with electric baseboards and no ducts at all.

A new high-efficiency furnace vents through plastic pipe in the side wall, so it no longer uses the chimney. If a gas water heater still vents up that chimney, it is now a small appliance in a flue sized for two. The flue gases cool before they reach the top, the draft weakens and moisture condenses inside the masonry. The usual fix is a liner sized for the water heater, or a water heater that vents on its own. Check whether a water heater pipe joins the chimney before the visit, and say so when you book.

If the house heats with baseboards and has no ductwork, a furnace means building a duct system first. A ducted or ductless heat pump is often the more practical choice in those houses.

What if there is no gas main on your street?

Not every street in town has one. A house converting from oil or electric heat needs gas at the property line before a gas furnace makes sense. The gas utility's new-customer page checks by postal code whether a property is in its service area, and it has a separate route for homes where natural gas is not on the street. Do that check before you plan the work.

Where there is no main, the choices change: a propane furnace, a heat pump, or keeping the existing system while you wait for a main. Each has a different running cost and a different install. The guide on the cheapest way to heat a Wasaga Beach home, with or without a gas main sets out the trade-offs.

Can a new furnace go into an old cottage crawlspace?

Sometimes, and it takes measuring first. The first cottages here went up in the early 1900s, mostly closely spaced on side streets between Mosley Street and the bay, and Oakview Beach joined the village in 1966. They were summer buildings with no central heating. Heat came later as baseboards, space heaters, or a furnace squeezed into a crawlspace.

A technician replacing one of those crawlspace furnaces meets three things: improvised ductwork, thin insulation and tight access. The new unit has to fit through the opening and meet its service clearances once it is in place. Ducts running through a cold crawlspace lose heat before it reaches the rooms, so sealing and insulating them can matter as much as the furnace itself. Where the ducts are past saving, a ductless heat pump may serve the cottage better than a new furnace.

Where should the vents go so snow does not shut the furnace down?

Above the snow, and away from where it drifts. Environment Canada's 1981-2010 normals for Thornbury Slama, the station on the shore west of town, show 266.6 cm of snow a year, with 79.1 cm in January and 70.8 cm in December. That is enough to bury a side-wall vent, a gas meter or a heat pump.

High-efficiency furnaces in newer houses, such as those in Sunnidale Trails, draw air and exhaust through two plastic pipes in the side wall. When those terminations drift over or ice up, the furnace shuts itself off. On a replacement, the vent route is planned with the snow in mind: high enough to clear a normal winter's buildup, off the side of the house where drifts collect, out from under roof edges that shed snow, and apart from the gas meter. After any heavy storm, go out and clear the pipes and the meter by hand.

How does a furnace installation go?

It starts with the house, not the label on the old furnace. The technician measures the rooms, looks at the windows and insulation, and works out the heat loss. The old furnace may have been oversized from the start, or the house may have changed since. The ductwork and return air are checked, because a new furnace pushed through ducts that are too small runs loud and wears early. The venting, the chimney and the gas line are checked as well.

You get a written price and approve it before any work starts. Work is performed by TSSA-certified gas technicians, and gas furnaces are installed to the CSA B149.1 Natural Gas and Propane Installation Code, adopted in Ontario under Ontario Regulation 212/01. The old furnace comes out, the new one goes in, and the system is started, tested for combustion and set up with the thermostat.

Register the new furnace with the manufacturer, since many manufacturer warranties depend on it. If the air conditioner is close to the end of its life too, read whether to replace the furnace and air conditioner together before you decide. When you are ready, ask for a price.

Our commitments

What can you count on from Wasaga Beach Furnace?

  • Licensed and insured

    Every technician holds a current TSSA gas technician certificate and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a technician calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about installation

Will the chimney need a liner when I replace the furnace?

Often, in Wasaga Beach houses built between the 1960s and 1990s. Many of them have a mid-efficiency furnace venting into a chimney. When that furnace is replaced with a condensing model that vents through the side wall, a gas water heater may be left alone in a chimney sized for two appliances, and it may not draft properly. The replacement quote should say what happens to the chimney. If the chimney stays in use, it may need a liner. Look at what else vents into your chimney before the visit, then see furnace installation and replacement.

All questions

Is your heat out, or is the cottage closing for winter?

Tell us what the system is doing and where the house is. You get a written price before any work starts.